Quanta Computer QuantaMesh User Manual - page 403
Manual is about: Layer 2/3/4 Managed Switch
of
1020
UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands
403
5.10.2 Configuration Commands
5.10.2.1 cdp
This command is used to enable CDP Admin Mode.
Syntax
cdp
no cdp
no - This command is used to disable CDP Admin Mode.
Default Setting
Enabled
Command Mode
Global Config
5.10.2.2 cdp run
This command is used to enable CDP on a specified interface.
Syntax
cdp run
no cdp run
no - This command is used to disable CDP on a specified interface.
Default Setting
Enabled
Command Mode
Interface Config