Quanta Computer QuantaMesh User Manual - page 233
UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands
233
5.3.6 SNMP Trap Commands
5.3.6.1 snmp-server host
This command configures traps to be sent to the specified host.
Syntax
snmp-server host
noauth | priv]} [filter
no snmp-server host
version 1 - Sends SNMPv1 traps.
version 2 - Sends SNMPv2 traps.
version 3 - Sends SNMPv3 traps.
auth - Enables authentication but not encryption.
noauth - No authentication or encryption. This is the default.
priv - Enables authentication and encryption.
aresent to this host. The range is 1 to 30 characters.
no - This command deletes trap receivers.
Default Setting
None
Command Mode
Global Config
5.3.6.2 show trapflags
This command displays trap conditions. Configure which traps the switch should generate by enabling or
disabling the trap condition. If a trap condition is enabled and the condition is detected, the switch's
SNMP agent sends the trap to all enabled trap receivers. The switch does not have to be reset to
implement the changes. Cold and warm start traps are always generated and cannot be disabled.
Syntax