Quanta Computer QuantaMesh User Manual - page 383
UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands
383
5.9.5.5 tacacs-server source-interface
Use this command in Global config mode to configure the source interface (Source IP address) for
TACACS+ server configuration. The selected source-interface IP address is used for filling the IP header
of management protocol packets. This allows security devices (firewalls) to identify the source packets
coming from the specific switch.
If a source-interface is not specified, the primary IP address of the originating (outbound) interface is
used as the source address.
Syntax
tacacs-server source-interface {
no tacacs-server source-interface
loopback ID is 0 to 7.
to 4093.
no - Use this command to remove the global source interface for all TACACS+ communications
between the TACACS+ client and the server.
Default Setting
None
Command Mode
Global Config