Quanta Computer QuantaMesh User Manual - page 658
UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Routing Commands
658
6.2.1.6 show ip route
This command displays the routing table. The
to be displayed and displays the best matching best-route for the address. The
subnet mask for the given
and
that prefix. Use the
best and nonbest routes. If you do not use the all parameter, the command only displays the best route.
If you use the connected keyword for
there are no best or non-best connected routes.
Syntax
show ip route [{
Default Setting
None
Command Mode
Privileged Exec
Display Message
Route Codes:
Displays the key for the routing protocol codes that might appear in the routing table
output.
The command displays the routing tables in the following format:
Code IP-Address/Mask [Preference/Metric] via Next-Hop, Interface
Code: The codes for the routing protocols that created the routes.
IP-Address/Mask:
The IP-Address and mask of the destination network corresponding to this route.
Preference:
The administrative distance associated with this route. Routes with low values are
preferred over routes with higher values.
Metric:
The cost associated with this route.
via Next-Hop: The outgoing router IP address to use when forwarding traffic to the next router (if
any) in the path toward the destination
Interface: The outgoing router interface to use when forwarding traffic to the next destination
!