Quanta Computer QuantaMesh User Manual - page 948
UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | IPv6 Commands
948
8.4.2 Configuration Commands
8.4.2.1 ipv6 ospf
This command enables OSPF on a router interface or loopback interface.
Syntax
ipv6 ospf
no ipv6 ospf
Default Setting
Disabled
Command Mode
Interface Config
8.4.2.2 ipv6 ospf areaid
This command sets the OSPF area to which the specified router interface belongs. The
IPv6 address, formatted as a 4-digit dotted-decimal number or a decimal value in the range of
<0-4294967295>. The
an area id, which does not exist on an interface, causes the area to be created with default values.
Syntax
ipv6 ospf areaid
the range of <0-4294967295>.
Default Setting
None
Command Mode
Interface Config