Quanta Computer QuantaMesh User Manual - page 443
UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands
443
5.12.2.15 lldp med transmit-tlv all
The user can go to the CLI Global Configuration Mode to set Type Length Values (TLVs) in the
LLDP-MED, use the lldp med transmit-tlv all [capabilities] [ex-pd] [ex-pse] [inventory][location]
[network-policy]Global configuration command. Use the no lldp med transmit-tlv all [capabilities]
[ex-pd] [ex-pse] [inventory] [location] [network-policy] to remove Type Length Values (TLVs) in the
LLDP-MED
Syntax
lldp med transmit-tlv all [capabilities] [ex-pd] [ex-pse] [inventory] [location] [network-policy]
no lldp med transmit-tlv all [capabilities] [ex-pd] [ex-pse] [inventory] [location] [network-policy]
capabilities - Transmit the LLDP capabilities TLV.
ex-pd - Transmit the LLDP extended PD TLV.
ex-pse - Transmit the LLDP extended PSE TLV.
inventory - Transmit the LLDP inventory TLV.
location - Transmit the LLDP location TLV.
network-policy - Transmit the LLDP network policy TLV.
Default Setting
None
Command Mode
Global Config
5.12.2.16 lldp dcbx version
This command is used to configure DCBX protocol version. Use the no lldp dcbx version to reset the
value to default.
Syntax
lldp dcbx version
no lldp dcbx version
auto - Configurethe switch to auto detect the peer DCBX version.
cee - Configure the switch to operate according to standard cee 1.06.
cin - Configure the switch to operate according to DCBX standard CIN 1.0 .
ieee - Configure the switch to operate according to standard IEEE 802.1Qaz.