Quanta Computer QuantaMesh User Manual - page 199
Manual is about: Layer 2/3/4 Managed Switch
of
1020
UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands
199
5.3.1.4 interface vlan
This command is used to create a vlan interface and enter Interface-vlan configuration mode.
Syntax
interface vlan
Default Setting
None
Command Mode
Global Config
5.3.1.5 ip address
This command sets the IP Address, and subnet mask. The IP Address and the gateway must be on the
same subnet.
Syntax
ip address
no ip address
no - Restore the default IP address and Subnet Mask
Default Setting
IP address: 0.0.0.0
Subnet Mask: 0.0.0.0
Command Mode
Interface-Vlan Config
Command Usage
Once the IP address is set, the VLAN ID’s value will be assigned to management VLAN.