Quanta Computer QuantaMesh User Manual - page 980
Manual is about: Layer 2/3/4 Managed Switch
of
1020
UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | IPv6 Commands
980
8.5.2.10 ipv6 rip passive-interface
The user can go to the CLI Interface Configuration Mode to set ipv6 rip passive, use the ipv6 rip
passive-interface interface configuration command. Use the no ipv6 rip passive-interface return to
the default value.
Syntax
ipv6 rip passive-interface
no ipv6 rip passive-interface
no - This command sets the RIPng timer to default value.
Default Setting
Disabled
Command Mode
Interface Config