Quanta Computer QuantaMesh User Manual - page 807
UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Routing Commands
807
6.11.2.18 neighbor password
This command is used to enable Message Digest 5 (MD5) authentication on a TCP connection between
two BGP peers, use the neighbor password command in Router BGP Config Mode. To disable this
function, use the no form of this command.
Syntax
neighbor
no neighbor < peeripaddr> password
peeripaddr: IP address of the neighboring router.
string: Case-sensitive password of up to 25 characters in length.
Default Setting
None
Command Mode
Router BGP Config Mode
6.11.2.19 neighbor connect-retry-interval
This command is used to specify a time interval at which the router attempts to open sessions to peers
that are not fully established. To return the router to default operation, use the no form of this command.
Syntax
neighbor
no neighbor
peeripaddr: IP address of the neighboring router.
connection-retry-interval: The valid range is 1 to 65535 seconds.
Default Setting
connection-retry-interval: The default is 2 seconds.
Command Mode
Router BGP Config Mode