Quanta Computer QuantaMesh User Manual - page 883
UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | IP Multicast Commands
883
mask for the group address. The optional keyword override indicates that if there is a conflict, the RP
configured with this command prevails over the RP learned by BSR.
Syntax
ipv6 pim rp-address
no ipv6 pim rp-address
override - Indicates that if there is a conflict, the RP configured with this command prevails over the
RP learned by BSR.
no - This command is used to remove the address of the configured PIM Rendezvous point (RP) for
the specified multicast group range.
Default Setting
None
Command Mode
Global Config
7.6.2.10 ipv6 pim rp-candidate
This command is used to configure the router to advertise itself as a PIM candidate rendezvous point
(RP) to the bootstrap router (BSR) for a specific multicast group range.
Syntax
ipv6 pim rp-candidate interface {
no ipv6 pim rp-candidate interface {
candidate RP address. This interface must be enabled with PIM.
address that is advertised in association with the RP address.
default value is 60.
no - This command is used to disable the router to advertise itself as a PIM candidate rendezvous
point (RP) to the bootstrap router (BSR).