Quanta Computer QuantaMesh User Manual - page 679
UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Routing Commands
679
6.3.1.3 show ip ospf area
This command displays information about the area. The
displayed.
Syntax
show ip ospf area
Default Setting
None
Command Mode
Privileged Exec
User Exec
Display Messages
AreaID: The area id of the requested OSPF area.
External Routing: A number representing the external routing capabilities for this area.
Spf Runs: The number of times that the intra-area route table has been calculated using this area's
link-state database.
Area Border Router Count: The total number of area border routers reachable within this area.
Area LSA Count: Total number of link-state advertisements in this area's link-state database,
excluding AS External LSA’s.
Area LSA Checksum: A number representing the Area LSA Checksum for the specified AreaID
excluding the external (LS type 5) link-state advertisements.
Flood List Length: Length of the area's LSA flood list.
Import Summary LSAs: Shows whether to import summary LSAs.
The following OSPF NSSA specific information displays only if the area is configured as an NSSA:
Import Summary LSAs: Shows whether to import summary LSAs into the NSSA.
No-Redistribute into NSSA: Shows whether to redistribute information into the NSSA.
Default Information Originate: Shows whether to advertise a default route into the NSSA.
Default Metric: The metric value for the default route advertised into the NSSA.
Default Metric Type: The metric type for the default route advertised into the NSSA.
Translator Role: The NSSA translator role of the ABR, which is always or candidate.
Translator Stability Interval: The amount of time that an elected translator continues to perform its
duties after it determines that its translator status has been deposed by another router.
Translator State: Shows whether the ABR translator state is disabled, always, or elected.