Quanta Computer QuantaMesh User Manual - page 730
UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Routing Commands
730
6.5.2 Configuration Commands
6.5.2.1 ip helper-address
Use this command to configure the relay of certain UDP broadcast packets received on a specific
interface or range of interfaces. This command can be invoked multiple times on a routing interface,
either to specify multiple server addresses for a given port number or to specify multiple port numbers
handled by a specific server.
Syntax
ip helper-address
netbios-dgm | netbios-ns | ntp | pim-auto-rp | rip | tacacs | tftp | time ]
no ip helper-address
netbios-dgm | netbios-ns | ntp | pim-auto-rp | rip | tacacs | tftp | time ]
no - This command is used to delete the address.
Default Setting
None
Command Mode
Interface Config
6.5.2.2 ip helper-address discard
Use this command to configure the discard of certain UDP broadcast packets received on a specific
interface or range of interfaces. This command can be invoked multiple times on a routing interface for a
given port number or to specify multiple port numbers handled by a specific server.
Syntax
ip helper-address discard {
| netbios-ns | ntp | pim-auto-rp | rip | tacacs | tftp | time }
no ip helper-address discard {
netbios-dgm | netbios-ns | ntp | pim-auto-rp | rip | tacacs | tftp | time }
no - This command is used to delete the address.
Default Setting
None
Command Mode
Interface Config