Quanta Computer QuantaMesh User Manual - page 296
Manual is about: Layer 2/3/4 Managed Switch
of
1020
UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands
296
5.4.2.11 spanning-tree auto-edge
This command sets the auto-edge for this port to enabled.
Syntax
spanning-tree auto-edge
no spanning-tree auto-edge
no - This command sets the auto-edge for this port to disabled.
Default Setting
Disabled
Command Mode
Interface Config
5.4.2.12 spanning-tree edgeport
This command sets the edguport function to Enabled or Disabled on this switch.
Syntax
spanning-tree edgeport
no spanning-tree edgeport
no - This command sets the Edgeport function to the default value, that is Enabled.
Default Setting
Enabled
Command Mode
Global Config