Quanta Computer QuantaMesh User Manual - page 434
UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands
434
5.12.2 Configuration Commands
5.12.2.1 lldp notification
This command uses to enable remote data change notifications.
Syntax
lldp notification
no lldp notification
no - This command is used to disable notifications.
Default Setting
Disbaled
Command Mode
Interface Config
5.12.2.2 lldp notification-interval
This command is used to configure how frequently the system sends remote data change notifications.
The
valid interval range is 5-3600 seconds.
Syntax
lldp notification-interval
no lldp notification-interval
no - This command is used to return the notification interval to the default value.
Default Setting
5
Command Mode
Global Config