Quanta Computer QuantaMesh User Manual - page 288
UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands
288
5.4.2.3 spanning-tree configuration
This command sets the Configuration Identifier Name for use in identifying the configuration that this
switch is currently using. The
Syntax
spanning-tree configuration name
no spanning-tree configuration name
no - This command resets the Configuration Identifier Name to its default.
Default Setting
The base MAC address displayed using hexadecimal notation as specified in IEEE 802 standard.
Command Mode
Global Config
This command sets the Configuration Identifier Revision Level for use in identifying the configuration that
this switch is currently using. The Configuration Identifier Revision Level is a number in the range of 0 to
65535.
Syntax
spanning-tree configuration revision <0-65535>
no spanning-tree configuration revision
no - This command sets the Configuration Identifier Revision Level for use in identifying the
configuration that this switch is currently using to the default value, that is, 0.
Default Setting
0
Command Mode
Global Config