Quanta Computer QuantaMesh User Manual - page 890
UANTA COMPUTER INC.
Layer 2/3/4 Managed Switch
QuantaMesh | IP Multicast Commands
890
7.7.2 Configuration Commands
7.7.2.1 ip igmp-proxy
This command enables the IGMP Proxy on the router. To enable the IGMP Proxy on the router, you
must enable multicast forwarding. Also, make sure that there are no multicast routing protocols enabled
on the router.
Syntax
ip igmp-proxy
no ip igmp-proxy
no - This command disables the IGMP Proxy on the router.
Default Setting
Disabled
Command Mode
Interface Config
7.7.2.2 ip igmp-proxy reset-status
This command resets the host interface status parameters of the IGMP Proxy router. This command is
valid only when you enable IGMP Proxy on the interface.
Syntax
ip igmp-proxy reset-status
Default Setting
None
Command Mode
Interface Config