3Com NBX 100 Administrator's Manual - page 135
Adding, Removing, and Modifying Telephones
135
4 Enable Auto Discover Telephones, and then click Apply.
5 Optionally, enable the Auto Add Phones to Call Pickup Group 0 check
box.
Regardless of whether you select this check box, you can change the call
pickup group for any telephone later. See
“Call Pickup”
on
page 228
for
information about Call Pickup Groups.
6 Click OK.
7 For each telephone that you want to autodiscover:
a Remove the telephone from the packing box.
b Connect the phone to power and the network according to the
instructions in the telephone packing sheet or the NBX Installation
Guide.
c Wait until an extension number appears in the telephone’s display
panel.
NBX devices that require a license, such as the 3102 Business Telephone,
the 3101 and 3101SP Basic Telephones, and the 3105 Attendant
Console, will not display an extension number until you add the license to
the system. If you have not entered a license for a telephone, its display
panel will show the device’s MAC address and a rotating hyphen.
You can now disconnect the telephone and move it to its destination. The
telephone retains its extension and button mappings.
Adding a Telephone Manually
To add a new telephone manually:
1 From the NBX NetSet main menu, click
Device Configuration > Telephones
.
2 Click
Add
. The Add Telephones dialog box appears.
3 Fill in the fields with the appropriate values. Click the Help button to see
more information about the dialog box fields.
4 Click Apply to configure this telephone. You can then configure
additional telephones using the same menu.
5 Click OK.