3Com NBX 100 Administrator's Manual - page 195
Configuring and Managing E1 Digital Line Cards
195
Viewing the Status of an E1 Card Channel
To view the status of a channel on an installed E1 card:
1 On the Digital Line Cards tab, select ISDN PRI Channel List from the
Select Device Type drop-down list and click Apply.
2 Select the channel for which you want status information.
3 Click Status.
4 View the status of the channel and then refresh the Channel Status
dialog box.
a From the Dialog Refresh drop-down list, select:
■
Manual — To manually refresh the Channel Status dialog box each
time that you click the Apply button.
■
A time interval (5, 10, 15, 30, or 60 seconds) — To refresh the
Channel Status dialog box at the specified intervals.
b Enable the Device Refresh check box.
5 Click Apply and then click OK.
Viewing DSP (Digital Signal Processor) Details
To view DSP (Digital Signal Processor) details:
1 Return to the Digital Line Cards tab.
2 From the Select Device Type list, select T1/ISDN Board List and click Apply.
3 Select the board you want and click Status.
4 In the Board Status dialog box, select a DSP from the DSP List and click
Details.
5 Click Close to close the DSP Status window.
Modifying IP Settings
for an E1 Card
You can modify the IP settings for an E1 card to meet changing
requirements.
3C10165D E1 Card Configuration Notes
■
3C10165D E1 Digital Line Cards do not support the NBX IP On-the Fly
feature. If your system uses IP On-the-Fly, then you must assign a static
IP address to the card or use DHCP to assign an IP address to the card,
even if the card will be installed on the same subnet as the NCP.
■
3C10165D E1 Digital Line Cards do not support DHCP option 184.
Before you install a 3C10165D card at a site that is remote from the