3Com NBX 100 Administrator's Manual - page 161
Configuring and Managing Analog Line Card Ports
161
To set Attendant Console Feature IP settings:
1 Select NBX NetSet > Device Configuration > Attendant Console.
2 Select the Attendant Console you want, and click IP Settings.
When you change IP Settings, all current calls through this device are
terminated.
Configuring and
Managing
Analog Line Card
Ports
Each NBX Analog Line Card provides access for up to four local telephone
lines into your NBX system. The Call Processor treats a line card port as an
extension, so each line card port needs its own extension number.
You use Auto Discovery to detect Line Card ports, and you define the
starting address for Auto Discovery of devices in the system dial plan. For
a 3-digit dial plan, the default starting address is 750; for a 4-digit dial
plan, the default starting address is 7250. Auto Discovery assigns the first
unassigned number, starting at 750 (or 7250 for a 4-digit dial plan), to
the first Line Card port.
You typically configure Line Cards during installation. See the NBX
Installation Guide for more information.
If you remove a line card from the system, the port information remains in
the database. The extension numbers assigned to the four ports do not
become available for reuse unless you use the NBX NetSet utility to
remove the line card from the configuration database.
This section covers these topics:
■
Configuring a Line Card Port
■
Modifying a Line Card Port
■
Removing a Line Card Port
■
Verifying Line Card Port Status
■
Rebooting a Line Card Port
■
Advanced Settings
Configuring a
Line Card Port
When you configure a line card port, you can assign it as a member of a
line pool.