3Com NBX 100 Administrator's Manual - page 169
Connecting and Managing Analog Devices
169
3 Fill in the fields in the Add ATA dialog box. Click the Help button to see
more information about the dialog box fields.
4 Click Apply to add the new ATA to the system.
5 Repeat as necessary to add more ATAs.
6 When you are finished adding ATAs, click OK.
Modifying an Analog
Terminal Port
You can modify the configuration of an Analog Terminal Card port or a
single-port ATA at any time.
To modify an analog device configuration:
1 Select NBX NetSet >
Device Configuration
> ATA.
2 Select the port that you want to modify and click Modify.
3 Modify the desired fields. Click the Help button to see more information
about the dialog box fields.
4 Click Apply to effect the changes.
5 Click OK.
Removing an Analog
Terminal Adapter
You can remove either an Analog Terminal Adapter (ATA) or one of the
ports on an Analog Terminal Card (ATC) from the system at any time. Any
device connected to the ATA is also removed from the system.
To remove an Analog Terminal Adapter:
1 Select NBX NetSet >
Device Configuration
> ATA.
Use the MAC addresses to determine whether an item in the list is an
Analog Terminal Adapter (ATA) or one of the ports on an Analog Terminal
Card. Ports on a 3C10117 Analog Terminal Card have MAC addresses
that differ by two hexadecimal digits. Ports on a 3C10117C Analog
Terminal Card all have the same MAC address and use a Virtual Device
Number to identify each port. The port number appears after the MAC
address, enclosed in square brackets. An ATA has a unique MAC address
with no port number.
2 Select the ATA or the port on an ATC you want to remove.
3 Click Remove. A dialog box prompts you to confirm the removal.
4 Click Yes. The system removes the item you selected.