3Com NBX 100 Administrator's Manual - page 182
182
C
HAPTER
3: D
EVICE
C
ONFIGURATION
Removing a BRI
Digital Line Card
You can remove a Digital Line Card at any time.
CAUTION: Removing a Digital Line Card may affect your Dial Plan.
To remove a Digital Line Card:
1 Onthe Digital Line Cards tab, from the Select Device Type drop-down list,
select T1/ISDN Board List and click Apply. A list of installed T1, ISDN PRI,
or ISDN BRI boards appears in the T1/ISDN Board List.
2 Select the board (Digital Line Card) you want to remove from the list.
3 Click Remove. A dialog box prompts you to confirm the removal.
4 Click Yes.
Configuring and
Managing E1
Digital Line Cards
This section describes how to add and configure an E1 Digital Line Card
to connect to an E1 service provided by the local telephone company. You
can configure an E1 Digital Line Card for ISDN PRI signaling only. In the
NBX NetSet utility, Digital Line Cards are referred to as either cards or
boards.
These topics explain NBX E1 card configuration:
■
Adding an E1 Digital Line Card
■
Configuring an E1 Digital Line Card
■
E1 Card Status Lights
■
Modifying an E1 Card
■
Adding or Modifying an E1 Group
■
Modifying E1 Card Channels
■
Modifying IP Settings for an E1 Card
■
Removing an E1 Digital Line Card
3C10165D E1 Digital Line Cards have expanded capabilities that are
described in these topics:
■
Setting Up a Digital Line Card at a Remote Location
■
Setting Up T1/E1 Logging
■
Viewing CSU State Information and Statistics
■
Using Loopback Tests