3Com NBX 100 Administrator's Manual - page 165
Configuring and Managing Analog Line Card Ports
165
5 Click OK.
Removing a
Line Card Port
When you remove a line card port that is already configured, you remove
the port information from the database.
To remove a line card port:
1 Select NBX NetSet >
Device Configuration
> Line Card Ports.
2 Select the port that you want to remove from the list.
3 Click Remove. A prompt asks you to confirm that you want to remove the
port.
4 Click Yes to remove the port.
Verifying Line Card
Port Status
You can verify the status of a configured line port at any time.
To view the status of a line card port:
1 Select NBX NetSet >
Device Configuration
> Line Card Ports.
2 Select the port that you want and click Status.
Click the Help button to see more information about the dialog box
fields.
Rebooting a
Line Card Port
To reboot a line card port:
1 Select NBX NetSet >
Device Configuration
> Line Card Ports.
2 From the list, select the port that you want to reboot.
3 Click Status. The Device Status dialog box appears.
4 Click Reset Device.
5 Click
OK
.
CAUTION: On the 3C10117 Analog Line Card, you can reboot individual
ports without affecting the other ports. However, if you reboot a port on
the 3C10114C Analog Line Card, all four ports on the card are rebooted.
Active telephone calls on any of these ports are disrupted.
Advanced Settings
The Advanced Settings button enables you to set the audio gain and
timing controls on each port of an Analog Line Card.