3Com NBX 100 Administrator's Manual - page 197
Configuring and Managing T1 Digital Line Cards
197
To remove a Digital Line Card:
1 Select NBX NetSet > Device Configuration > Digital Line Cards.
2 From the Select Device Type drop-down list, select T1/ISDN Board List and
click Apply. A list of installed T1, ISDN PRI, and ISDN BRI boards appears in
the T1/ISDN Board List.
3 Select the board (Digital Line Card) you want to remove from the list.
4 Click Remove. A dialog box prompts you to confirm the removal.
5 Click Yes.
Configuring and
Managing T1
Digital Line Cards
These sections describe how to add and configure a T1 Digital Line Card
to connect to a T1 service provided by the local telephone company:
■
Adding a T1 Digital Line Card
■
Configuring a T1 Digital Line Card for the DS1 Protocol
■
Configuring a T1 Digital Line Card for ISDN PRI Signaling
■
T1 Card Status Lights
■
Modifying a T1 Card
■
Modifying a T1 Group
■
Modifying T1 Card Channels
■
Modifying IP Settings for a T1 Card
■
Removing a T1 Digital Line Card
The NBX NetSet utility refers to Digital Line Cards as cards or boards.
3C10116D T1 Digital Line Cards have expanded capabilities that are
described in these topics:
■
Setting Up a Digital Line Card at a Remote Location
■
Setting Up T1/E1 Logging
■
Viewing CSU State Information and Statistics
■
Using Loopback Tests
You can configure the T1 Digital Line Card to use one of two types of
signaling:
■
DS1 protocol (sometimes referred to as “Standard T1”)