Oce cm3530 Network Administrator's Manual - page 148
148
Network Administrator’s Guide — Registering from Imagistics Printer Utility
3) Destination — Remote 1
Check this box to save a received document to the Remote 1. How you can set this item
depends on how the Remote 1 has been set up in the Save as file submenu in the Setup
menu.
If the Remote 1 does not allow to specify a network folder, you can only select “Use Admin-
istrator Settings”. The protocol and the network path are displayed below this item.
If the Remote 1 allows to specify a network folder, you can select “Use User Settings” and
specify the network folder settings by entering the following items:
Protocol
Select the protocol to be used for uploading a received document to the network folder.
•
SMB — Select this to send a received document to the network folder using the SMB
protocol. The SMB protocol can be used in the network that the Windows file sharing
service is enabled.
•
FTP — Select this to send a received document to the FTP server.
Server Name
Enter the FTP server name or IP address where a received document will be sent. For exam-
ple, to send a received document to the “ftp://192.168.1.1/user/scanned” FTP folder in the
FTP server, enter “192.168.1.1” in this field. This must be entered only when you select
“FTP” for the protocol. You can specify the directory at the “Network Path” field.
Port Number (Command)
Enter the port number to be used for controls if you select “FTP” as the protocol. Generally
“-” is entered for the control port. When “-” is entered, the port number, that is set at “FTP
Client” in the Network menu page of the Setup tab, will be used. Change this option if you
want to use another port number.
Network Path
Enter the network path to store a received document. When you select “SMB” as the proto-
col, enter the network path to the network folder. For example, to specify the
“users\scanned” folder in the computer named “Client01”, enter “\\Client01\users\scanned”.
When you select “FTP” as the protocol, enter the directory in the specified FTP server. For
example, to specify the “ftp://192.168.1.1/user/scanned” FTP folder in the FTP server, enter
“user/scanned”.
Login User Name
Enter the login user name to access a Windows computer or an FTP server, if required.
When you select “FTP” as the protocol, an anonymous login is assumed if you leave this
field blank.
Password
Enter the password to access a Windows computer or an FTP server, if required.
Retype Password
Enter the same password again for a confirmation.
4) Destination — Remote 2
Check this box to save a received document to the Remote 2. How you can set this item
depends on how the 2st Folder has been set up in the Save as file submenu in the Setup
menu.
If the Remote 2 does not allow to specify a network folder, you can only select “Use Admin-
istrator Settings”. The protocol and the network path are displayed below this item.
If the Remote 2 allows to specify a network folder, you can select “Use User Settings” and
specify the network folder settings. Please refer to the description of the Remote 1 option
for each item.
5) File Name
Display how the a received document will be named. You cannot change the file name.