Oce cm3530 Network Administrator's Manual - page 82
82
Network Administrator’s Guide — Setting up Printer Settings
SUPPLEMENT:
•
You can also add LPR queue names and specify the raw job setting for each queue.
P.83 "Setting up the Raw Job Setting"
1) Raw jobs - Duplex Printing
Select whether a raw job will be printed on both sides of the paper.
2) Raw jobs - Default Paper Size
Select the default paper size that applies to a raw job.
3) Raw jobs - Default Paper Type
Select the default paper type that applies to a raw job.
4) Raw jobs - Default Orientation
Select the default orientation that applies to a raw job.
5) Raw jobs - Default Stapling
Select whether a raw job will be stapled.
6) Raw jobs - Default Output Tray
Select the default output tray that applies to a raw job. A banner page that is created by
NetWare, UNIX, and Windows operating systems also will be outputted to the tray set here.
7) PCL Form Line
Enter the number of lines printed per page.
8) PCL Font Pitch
Enter the font pitch when the selected font number represents a fixed pitch scalable font.
Pitch is measured by characters per inch, so a 10-pitch is ten characters per inch.
9) PCL Font Point Size
Enter the font size when the selected font number represents a proportionally spaced scal-
able font. The Font Size option allows you to determine the point size (height) of the default
font.
10) PCL Font Number
Enter the font number of the internal PCL font to be used as the default font for printing. You
can check the font numbers and internal PCL fonts in the Internal PCL Font List. Please see
the Printing Guide for the font number of internal PCL fonts,
11) PCL Line Termination
Select the type of the line termination.
12) Paper Source
Select the paper source that applies to a raw job.
1
2
3
4
5
6
7
8
9
10
11
12
13