Oce cm3530 Network Administrator's Manual - page 52

52

Network Administrator’s Guide — Setting up Network Settings

2) IP Address

Enter the static IP address that is assigned to this equipment when “Static IP” is selected in

the “Address Mode” drop down box.

3) Subnet mask

Enter the subnet mask if required when “Static IP” is selected in the “Address Mode” drop

down box.

4) Default Gateway

Enter the gateway address if required when “Static IP” is selected in the “Address Mode”

drop down box.

Setting up the IPX/SPX

You can set the IPX/SPX protocol to enable the communication over IPX/SPX.  The IPX/SPX

must be configured to enable Novell printing with NetWare server 4.x, 5.x, 6.x over IPX/SPX.

1) Enable IPX/SPX

Select whether the IPX/SPX protocol is enabled or disabled.  Please enable this when con-

figuring Novell printing over the IPX/SPX network.

2) Frame Type

Select the desired frame type for IPX/SPX.

•

Auto Sense — Select this to use an appropriate frame type that the equipment found

first.

•

IEEE 802.3/Ethernet II/IEEE 802.3 Snap/IEEE802.2 — Instead of “Auto Sense”,

select the frame types to be used from these options.

3) Actual Frame

This displays the actual frame type of the equipment.

4) Enable NCP Burst

Select whether the NCP Burst mode is enabled or disabled.  When this is enabled, it can

increase the efficiency of communication between this equipment and NetWare file server.

Setting up the AppleTalk

You can set the protocol to enable communication over AppleTalk.  The AppleTalk must be con-

figured to enable AppleTalk printing from Macintosh computers.

1) Enable Apple Talk

Select whether the AppleTalk protocol is enabled or disabled.  Please enable this when con-

figuring AppleTalk printing.

1

2

3

4

1

2

3

4