Oce cm3530 Network Administrator's Manual - page 51

Network Administrator’s Guide — Setting up Network Settings

51

 P.57 "Setting up the SMTP Client"

 P.58 "Setting up the SMTP Server"

 P.59 "Setting up the POP3 Network Service"

 P.60 "Setting up the FTP Client"

 P.60 "Setting up the FTP Server"

 P.61 "Setting up the SNMP Network Service"

4.

Click [Save].

• The confirmation dialog box appears.

SUPPLEMENT:

•

If you want to restore the current settings without saving the changes, click [Cancel].

Clicking [Cancel] cannot restore the defaults.  This can only clear the changes and

restore the current settings before saving the changes.

5.

Click [OK] to apply the changes.

• This equipment starts initializing the network interface card to apply 

the changes

Setting up the TCP/IP

You can set the TCP/IP protocol to enable communication over TCP/IP.  The TCP/IP must be

configured to enable Imagistics Printer Utility, SMB printing, Peer-to-Peer printing, LPR print-

ing, IPP printing, Save as file to network folder, Scan to Email, and Internet Fax.

1) Address Mode

Select how to set the IP address.

•

Static IP — Select this to assign the static IP address manually.  When this is selected,

enter the static IP address in the IP Address field.

•

No AutoIP — Select this to assign the IP address using the DHCP with Auto-IP

addressing disabled. When this is selected, the IP address, subnet mask, default gateway,

primary WINS server address, secondary WINS server address, POP3 server address,

and SMTP server address can be automatically obtained from the DHCP server if the

network supports the DHCP, but the IP address will not be assigned if the network does

not support the DHCP.

•

Dynamic — Select this to assign the IP address using the DHCP with Auto-IP address-

ing enabled.  When this is selected, the IP address, subnet mask, default gateway, pri-

mary WINS server address, secondary WINS server address, POP3 server address, and

SMTP server address can be automatically obtained from the DHCP server if the net-

work supports the DHCP, and the IP address can be also assigned using Auto-IP address-

ing even if the network does not support the DHCP.

1

2

3

4