Oce cm3530 Network Administrator's Manual - page 47
Network Administrator’s Guide — Setting up Device Settings
47
SUPPLEMENT:
•
If you want to restore the current settings without saving the changes, click [Cancel].
Clicking [Cancel] cannot restore the defaults. This can only clear the changes and
restore the current settings before saving the changes.
5.
Click [OK] to apply the changes.
NOTE:
•
When using the Internet Explorer, the settings that are displayed in each field may
not be changed even if you change the settings and click [Save]. However, the set-
tings have been changed in the equipment. In that case, click the General submenu
then the page displays the current settings in each field.
Setting up the Device Information
You can set the device information displayed in the Device tab page.
1) Name
This displays the equipment’s device name.
2) Copier Model
This displays the equipment’s model name.
3) Hard Disk Space Available
This displays the equipment’s available hard disk space.
4) Department Code
Select whether the department management is enabled or disabled.
5) Department Code Enforcement
Select whether invalid jobs, which a department code is not specified or invalid department
code is specified, are printed or stored in the invalid job list when the department code is
enabled.
•
OFF — Select this to print the invalid jobs.
•
ON — Select this to not print the invalid jobs and store them in the invalid job list.
NOTE:
•
If the Department Code Enforcement is set to ON and the SNMP communication is
enabled in the printer driver, the user will be prompted to enter the correct depart-
ment code if an invalid department code was entered in the printer driver.
1
2
3
4
5
6
7
8
9
10
11