Oce cm3530 Network Administrator's Manual - page 69
Network Administrator’s Guide — Setting up Fax Settings
69
12) Exposure
Select the default exposure for sending faxes.
Select “Auto” to automatically apply the ideal contrast according to the original or select the
contrast manually in 11 stages.
13) TTI
Select whether printing a transmission header (TTI) to identify the sender of received faxes.
14) RTI
Select whether printing a reception header (RTI) on received faxes to clearly identify the
time, date, and page count of received faxes.
15) ECM
Select whether enabling or disabling the ECM (Error Correction Mode) to automatically
re-send any portion of the document affected by phone line noise or distortion.
16) Discard
Select whether discarding the lower portion of the received fax image if it is larger than the
recording paper.
17) Reduction
Select whether reducing the received fax image if it is larger than the effective printing area
of the recording paper.
18) Duplex Print
Select whether printing the received fax images on both sides of the recording paper.
19) Rotate Sort
Select whether rotating the output direction in the tray for each reception.
20) Recovery Transmit
Select whether re-transmitting a fax after failing the initially specified number of redial
attempts. When this is enabled, select the stored time length from 1 to 24 hours.
21) Journal Auto Print
Select whether automatically printing a transmission and reception journal after every trans-
mission is completed.
22) Memory Transmission Report
Select how to print a result report after a memory transmission.
•
OFF — Select this to not print a memory transmission report.
•
Always — Select this to print a memory transmission report with all page images for
each memory transmission is completed.
•
ON ERROR — Select this to print a memory transmission report with all page images
only when the memory transmission is not successfully completed.
•
Always (Print 1st Page Image) — Select this to print a memory transmission report
with the 1st page image for each memory transmission is completed.
•
ON ERROR (Print 1st Page Image) — Select this to print a memory transmission
report with the 1st page image only when the memory transmission is not successful.
23) Multi Transmission Report
Select how to print a result report after a multi-address transmission.
•
OFF — Select this to not print a multi-address transmission report.
•
Always — Select this to print a multi-address transmission report with all page images
for each multi-address transmission is completed.
•
ON ERROR — Select this to print a multi-address transmission report with all page
images only when the multi-address transmission is not successfully completed.
•
Always (Print 1st Page Image) — Select this to print a multi-address transmission
report with the 1st page image for each multi-address transmission is completed.
•
ON ERROR (Print 1st Page Image) — Select this to print a multi-address transmis-
sion report with the 1st page image only when the multi-address transmission is not suc-
cessful.