Oce cm3530 Network Administrator's Manual - page 86

86

Network Administrator’s Guide — Setting up Print Service Settings

SUPPLEMENT:

•

If you want to restore the current settings without saving the changes, click [Cancel].

Clicking [Cancel] cannot restore the defaults.  This can only clear the changes and

restore the current settings before saving the changes.

5.

Click [OK] to apply the changes.

NOTE:

•

When using the Internet Explorer, the settings that are displayed in each field may

not be changed even if you change the settings and click [Save].  However, the set-

tings have been changed in the equipment.  In that case, click the Print Service sub-

menu then the page displays the current settings in each field.

Setting up the Raw TCP Print

In Raw TCP Print, you can enable or disable the Raw TCP print service.

1) Enable Raw TCP

Enable or disable Raw TCP print service.

2) Port Number

If enabling the Raw TCP, enter the Raw TCP port number for the Raw TCP print.  Generally

“9100” is used.

3) Enable Raw bi-directional

Enable or disable Raw bi-directional communication.

Setting up the LPD Print

In LPD Print, you can set the LPD print options to enable the LPD/LPR print service.

1) Enable LPD

Enable or disable LPD print service.

2) Port Number

If enabling the LPD, enter the LPD port number.  Generally “515” is used.

3) Banners

Select whether printing a banner page for each print job using LPR printing.

1

2

3

1

2

3