Oce cm3530 Network Administrator's Manual - page 24
24
Network Administrator’s Guide — Setup Flow for Printing Features
•
Document Monitor
•
Agfa Font Manager
Setup Flow for Peer-to-Peer Printing
This equipment provides the Peer-to-Peer Utility, (for Windows 98 and Windows Me), that
enables a peer-to-peer connection over the TCP/IP network. The Peer-to-Peer Utility allows
users to add the Peer-to-Peer TCP/IP port by searching for the equipment in the local area net-
work. If an administrator does not allow printer sharing in a Windows network, (which means
the SMB print service is disabled), he or she can permit users to connect to this equipment using
the Peer-to-Peer Utility.
NOTE:
•
Document Monitor cannot be used when you configure the printer connection using
the Peer-to-Peer utility.
Setup procedure
Step 1: Setting up the TCP/IP and the HTTP Network Service to enable Imagis-
tics Printer Utility.
You should set the TCP/IP and HTTP Network Service from the Touch Panel Display the
first time you use it, to make Imagistics Printer Utility available. Please see the User Func-
tions Guide to configure the TCP/IP and HTTP Network Service from the Touch Panel Dis-
play, or from Imagistics Printer Utility.
P.51 "Setting up the TCP/IP"
P.56 "Setting up the HTTP Network Service"
Step 2: Advise users to install the Client Software for Peer-to-Peer printing.
Users can get the printer drivers for Peer-to-Peer printing by installation from the Client1
CD-ROM. For more information about the Peer-to-Peer installation, please see the Printing
Guide.
In the Peer-to-Peer enabled network, users must install following client software for print-
ing:
•
Printer Drivers
•
Peer-to-Peer Utility
•
Agfa Font Manager
Windows 98
Windows Me
Windows 98
Windows Me
Windows 98
Windows Me
Connecting over TCP/IP Network
Setting up the TCP/IP
printer connection with
Peer-to-Peer Utility