Oce cm3530 Network Administrator's Manual - page 75

Network Administrator’s Guide — Setting up Save as file Settings

75

2) Use Network Folder Destination

Select this to allow network folders to be used as Save as file destinations for N/W-Fax doc-

uments.  When selected, set the N/W-Fax Folder settings to specify which network folder to

use.

Setting up the N/W-Fax Folder

In the N/W-Fax Folder, you can specify in which network folder N/W-Fax documents are saved.

1) Protocol

Select the protocol for uploading an N/W-Fax document to a network folder.

•

SMB — Select this to upload an N/W-Fax document to the network folder using the

SMB protocol.  SMB can be used in a Windows network when Windows file sharing

service is enabled.

•

FTP — Select this to upload a file to the FTP server.

2) Server Name

Enter the FTP server name or IP address where an N/W-Fax document will be sent.  For

example, to send  an N/W-Fax document to the “ftp://192.168.1.1/user/nw-fax” FTP folder

in the FTP server, enter “192.168.1.1” in this field.  This must be entered only when you

select “FTP” as the protocol.  You can specify the directory at the “Network Path” field.

3) Port Number (Command)

Enter the port number to be used for controls, if you select “FTP” as the protocol.  Generally

“-” is entered for the control port.  When “-” is entered, the port number, that is set at “FTP

Client” in the Network menu page of the Setup tab, will be used.  Change this option if you

want to use another port number.

4) Network Path

Enter the network path to store an N/W-Fax document.

When you select “SMB” as the protocol, enter the network path to the network folder.  For

example, to specify the “users\nw-fax” folder in the computer named “Client01”, enter

“\\Client01\users\nw-fax\”.

When you select “FTP” as the protocol, enter the directory in the specified FTP server.  For

example, to specify the “ftp://192.168.1.1/user/nw-fax” FTP folder in the FTP server, enter

“user/nw-fax”.

5) Login User Name

Enter the login user name to access a Windows computer or FTP server, if required.  When

you select “FTP” as the protocol, anonymous login is assumed if you leave this field blank.

6) Password

Enter the password to access a Windows computer or FTP server, if required.

7) Retype Password

Enter the same password again for a confirmation.

1

2

3

4

5

6

7