Oce cm3530 Network Administrator's Manual - page 22

22

Network Administrator’s Guide — Setup Flow for Printing Features

Setup Flow for LPR Printing

This equipment can be used with LPR printer connection for Windows NT 4.0, Windows 2000,

Windows XP, and Windows Server 2003. LPR printing is the common method to setting up the

printer from servers.  It is better to use LPR printing for Windows NT 4.0, Windows 2000, Win-

dows XP, and Windows Server 2003 rather than SMB printing because the printing process of

LPR printing is shorter than SMB printing.

Setup procedure

Step 1: Setting up the TCP/IP and the HTTP Network Service to enable Imagis-

tics Printer Utility.

You should set the TCP/IP and HTTP Network Service from the Touch Panel Display the

first time you use it, to make Imagistics Printer Utility available.  Please see the User Func-

tions Guide to configure the TCP/IP and HTTP Network Service from the Touch Panel Dis-

play, or from Imagistics Printer Utility.

 P.51 "Setting up the TCP/IP"

 P.56 "Setting up the HTTP Network Service"

Step 2: Setting up the LPD Print Service.

 P.86 "Setting up the LPD Print"

Step 3: Setting up the Raw TCP if required.

If you permit a Raw TCP connection for printing, which can be used with Windows 2000,

Windows XP, and Windows Server 2003 TCP/IP, please configure the Raw TCP/IP Print as

well.

 P.86 "Setting up the Raw TCP Print"

Step 4: Advise users to install the Client Software for LPR printing.

Users can install the printer drivers for LPR printing by installation from the Client1

CD-ROM and add the LPR port. For more information about the LPR installation, please see

the Printing Guide.

In the LPR enabled network, users must install following client software for printing:

•

Printer Drivers

•

Document Monitor

•

Agfa Font Manager

Windows NT 4.0

Windows 2000

Windows XP

Windows Server 2003

Connecting over TCP/IP Network

Setting up the LPR

printer connection