Oce cm3530 Network Administrator's Manual - page 54

54

Network Administrator’s Guide — Setting up Network Settings

Setting up the DNS Session

In DNS Session, you can specify the DNS server to enable the FQDN rather than the IP address

on specifying each server address such as SMTP server, POP3 server, and LDAP server.

SUPPLEMENT:

•

When the DNS service is enabled and the DNS server supports the dynamic DNS

service, please set the DDNS Session as well.

 P.54 "Setting up the DDNS Session"

1) Enable DNS

Select whether the DNS server is used or not.

2) Primary DNS Server Address

Specify the IP address of the primary DNS server when the DNS service is enabled.

3) Secondary DNS Server Address

Specify the IP address of the secondary DNS server when the DNS service is enabled, as you

require.

Setting up the DDNS Session

In DDNS Session, you can enable the Dynamic DNS service if the DNS server supports the

dynamic DNS.

1) Enable DDNS

Select whether the dynamic DNS service is enabled or disabled.

2) Host Name

Enter the host name that will be added to the DNS server using DDNS.

3) Domain Name

Enter the domain name that will be added to the DNS server using DDNS.

Setting up the SLP Session

In SLP Session, you can enable or disable the SLP (Service Location Protocol) over TCP/IP

environments.

1) Enable SLP

Select whether the SLP is enabled or disabled.  Please enable this when you configure a

Novell printing environment using the NetWare server over the TCP/IP network.

1

2

3

1

2

3

1