Oce cm3530 Network Administrator's Manual - Setting Up Copier Settings

Network Administrator’s Guide — Setting up Copier Settings

63

Setting up Copier Settings

In the Copier submenu page in the Setup menu, an administrator can configure the copier set-

tings that initially apply to copy operations.

NOTE:

•

Some settings may not apply to the Touch Panel Display as soon as you save the

settings.  When you change the settings, press the [RESET] button on the Control

Panel before an operation.

Setting the copier settings

1.

Access Imagistics Printer Utility in the administrator mode.

 P.15 "Accessing Imagistics Printer Utility Administrator Mode"

2.

Click the Setup menu and Copier submenu.

• The Copier submenu page is displayed.

3.

In the Copier submenu page, set the copier settings as 

required.

• To set the Copier Settings, see the following:

 P.64 "Setting up the Copier Settings"

4.

Click [Save].

• The confirmation dialog box appears.

SUPPLEMENT:

•

If you want to restore the current settings without saving the changes, click [Cancel].

Clicking [Cancel] cannot restore the defaults.  This can only clear the changes and

restore the current settings before saving the changes.