Oce cm3530 Network Administrator's Manual - page 55

Network Administrator’s Guide — Setting up Network Settings

55

Setting up the SMB Session

In SMB Session, you can specify the SMB network properties to enable SMB printing.  When

you enable the SMB, users can also browse the local folder in the equipment.  You can also spec-

ify the WINS server when the WINS server is used to enable the Windows print sharing and

Windows file sharing services between the different subnets.

1) SMB Protocol

Select whether the SMB protocol is enabled or disabled.

•

Enable — Select this to enable SMB.

•

Disable — Select this to disable SMB.

•

Disable Print Share — Select this to enable the file sharing service using SMB, and

disable the SMB printing.

2) NetBIOS Name

Enter the NetBIOS name of this equipment.

NOTE:

•

You can enter only alphanumeric characters and “-” (hyphenation) for NetBIOS

name.  If you use any other characters, the equipment uses “MFP-

Number>”, which is the default NetBIOS name.

3) Workgroup

Enter the Windows workgroup that this equipment joins.

NOTE:

•

You can enter only alphanumeric characters and symbols except following charac-

ters for Work Group.

; : “ < > * + = \ | ? ,

If you use any other characters, the equipment uses “workgroup”, which is the

default Work Group.

4) Primary WINS Server

Specify the IP address of the primary WINS server when the WINS server is used to provide

the NetBIOS name in your local area network.

5) Secondary WINS Server

Specify the IP address of the secondary WINS server as you require when the WINS server

is used to provide NetBIOS name in your local area network.

NOTES:

•

If “0.0.0.0” is entered for Primary WINS Server and Secondary WINS Server, this

equipment will not use the WINS server.

•

When “Dynamic” or “No AutoIP” is selected for the Address Mode in the TCP/IP set-

ting, the primary WINS server and secondary WINS server are automatically

obtained from the DHCP server.  However, if you enter the static IP address in these

fields, this equipment uses entered IP addresses instead of obtained IP addresses

from the DHCP server.

1

2

3

4

5