Rauch QUANTRON-A Instruction Manual - page 23
Attachment and installation
17
3
3.3
Connecting the control unit
Depending on the equipment, there are different methods of attaching the control
unit to the machine. Schematic connection diagrams:
for the standard connection, see
for the connection with the wheel sensor, see
,
for the connection with the wheel sensor and machine cable, see
.
Proceed in the following order.
Select a suitable position in the tractor cabin (within
the driver's field of vi-
sion
) to fix the control unit.
Fix the control unit by means of
brackets
in the tractor cabin.
Connect the control unit to the 7-pin socket or to the forward speed sensor
(depending on the equipment, see
).
Connect the control unit to the actuators of the machine using the 39-pin ma-
chine cable.
Connect the control unit to the tractor's power supply using the 3-pin plug con-
nector.
NOTICE
After having switched on the QUANTRON-A control unit, the display shows the
machine number for a short time.
NOTICE
Note the machine number
The control unit QUANTRON-A has been calibrated at the factory for the mineral
fertiliser spreader with which it was supplied.
Only connect the control unit to the correct mineral fertiliser spreader.