Rauch QUANTRON-A Instruction Manual - page 92
Spreading operation with the QUANTRON-A control unit
5
86
7.
Wait until the progress bars have entirely passed through.
Idle measurement is finished.
Idle time is reset to 20 min.
8.
Press the
Start/Stop
key.
The spreading starts.
As long as the PTO is operating, a new idle measurement will start after the ex-
piration of the idle time automatically every 20 minutes at the latest.
Under certain conditions, idle measurement to capture new reference data is re-
quired before you continue spreading.
As soon as idle measurement during spreading is required, the information
screen will appear.
In case of unusual flow factor changes, the empty run measurement must be
started
manually
.
Requirements:
Spreading work is stopped (Start/Stop key or both sections deactivated).
The operating screen is displayed.
The PTO speed is at least 400rpm.
1.
Press the
Enter key
.
The display shows the idle measurement screen.
The idle measurement starts.
2.
Adjust the PTO speed, if necessary.
The bar shows the progress.
NOTICE
As soon as the metering slides close (e.g. in the headline or by pressing the
Start/Stop
key), the
M EMC function
will start an empty run measurement in
the background (without information screen).
To this end, the PTO speed must remain at the preset value during idle
measurement!
NOTICE
If you want to observe the time until the next empty run measurement, you can
also assign the freely selectable display fields in the operation screen with
Idle
time
4.9.2: Display configuration, page 68
NOTICE
When starting the disc and after disc type change, a new idle measurement is
mandatory!