Rauch QUANTRON-A Instruction Manual - page 88
Spreading operation with the QUANTRON-A control unit
5
82
5.2
TELIMAT
TELIMAT with hydraulic remote control
The TELIMAT is hydraulically moved to its working or idle position. The TELIMAT
can be activated or deactivated by pressing the
T key
. Depending on the position,
the display shows or hides the
TELIMAT icon
.
TELIMAT with hydraulic remote control and TELIMAT sensors
If TELIMAT sensors are connected and activated, the
TELIMAT icon
is shown
on the display of the control unit as soon as the TELIMAT has been hydraulically
brought to the operating position. If the TELIMAT is moved back to the idle posi-
tion, the
TELIMAT icon
is hidden. The sensors monitor the TELIMAT adjustment
and activate or deactivate the TELIMAT automatically. The
T key
has no function
for this option.
If the status of the TELIMAT unit cannot be verified for more than 5 seconds,
alarm message 14
will be displayed. Refer to chapter
.
n
CAUTION
Risk of injury due to the automatic adjustment of the TELIMAT!
By pressing the
T
key
, the unit automatically moves to the bound-
ary spreading position by means of an electrical actuating cylinder.
This may cause injury and property damage.
Before pressing the
T key
, make sure that no one is in the
danger area of the machine.
NOTICE
The Telimat option is preset for the control unit at the factory!