Rauch QUANTRON-A Instruction Manual - page 62
Operation QUANTRON-A
4
56
4.6.3
+/- quantity
In this menu, an
Application rate adjustment
percentage for standard spread-
ing can be specified.
The preset value of the metering slide opening serves as basis (100%).
Specifying the quantity reduction:
1.
Open the
Machine settings > +/- Quantity (%)
menu.
2.
Enter the percentage by which the application rate is to be adjusted.
Refer to chapter
4.12.2: Entering values with the cursor keys, page 79
.
3.
Press the
Enter key
.
4.6.4
Signal for empty run measurement
Here you can activate or deactivate the signal tone for the accomplishment of the
empty run measurement.
1.
Highlight the
empty run measurement
menu item.
2.
Activate the option by pressing the
Enter key
.
The display shows a tick.
There is an acoustic signal for each start of an automatic idle measure-
ment.
3.
Deactivate the option by pressing the
Enter key
once more.
The tick disappears.
NOTICE
During operation, you can use the
F2/F3
function keys to change the application
rate by the factor of
+/- application rate
at any time.
By pressing the
C 100 % key
you reset the presettings.