Rauch QUANTRON-A Instruction Manual - page 41
Operation QUANTRON-A
35
4
Display of flow factor with M EMC function
Enter a value for the flow factor in the
flow factor
submenu as a standard. How-
ever, during spreading and with enabled
M EMC function
, the control unit con-
trols the left and the right metering slide separately. Both values are shown on the
operating screen.
When pressing the
Start/Stop
key, the display updates the indicated flow factor
with a slight delay. Then, the display is updated in regular intervals.
Figure 4.8:
Left and right flow factor are controlled separately (enabled M
EMC function).
[1] Flow factor for the right metering slide.
[2] Flow factor for the left metering slide.
NOTICE
It is recommended to have the flow factor displayed in the operating screen.
Thus you can observe the mass flow control during spreading. Please refer to
chapter
4.9.2: Display configuration, page 68
and chapter
2
1