Rauch QUANTRON-A Instruction Manual - page 53
Operation QUANTRON-A
47
4
Adjustment of section values
Requirements: The VariSpread calculation menu item is highlighted.
1.
Press the arrow down key.
The input field for the first value in the chart is highlighted.
2.
Use the
Arrow up / arrow down
keys to enter the value.
3.
Use the
Arrow right
key to change over to the subsequent number to be
modified.
4.
Press the
Enter key
.
The value is stored.
5.
Use the
Arrow right
key to change over to the subsequent input field to be
modified.
6.
Adjust the values to your requirements.
See also
“Entering values with the cursor keys“ on page 79
.
7.
Check the values in the table.
NOTICE
To reset the adjusted values to the automatically calculated values, press
VariSpread calculation
.
Use the
Arrow left
key to navigate upwards through the chart up to the
VariSpread calculation
item.
NOTICE
If the working width or the drop point is not adjusted in the
Fertiliser settings
menu, the VariSpread calculation will be implemented automatically in the back-
ground.