Rauch QUANTRON-A Instruction Manual - page 89
Spreading operation with the QUANTRON-A control unit
83
5
5.3
Working with sections
5.3.1
Spreading with reduced sections
You can spread with sections on one or both sides and thus adapt the entire
spreading width to the field requirements. Each spreading side can be adjusted
in 4 (VariSpread 8) or 2 (VariSpread 4) steps.
Press the
L%/R%
key until the desired function keys are displayed.
Figure 5.1:
Operating screen for spreading operation with sections
[1] Right section will spread to the entire half
[2] Increase or reduce right spreading width function keys
[3] Increase or reduce left spreading width function keys
[4] Left section is reduced to 2 steps
1.
Press the
Reduce left spreading width
function key or the
Reduce right
spreading width
function key.
The section of the spreading side will be reduced by one step.
2.
Press the
Increase left spreading width
function key or the
Increase right
spreading width
function key.
The section of the spreading side will be increased by one step.
NOTICE
Each section can be gradually reduced or increased in 2 and/or 4 steps.
NOTICE
The sections are not rated proportionally. You can set the spreading widths via
the VariSpread spreading width assistant.
See
4.5.12: Varispread calculation, page 46
.
2
3
4
1