Rauch QUANTRON-A Instruction Manual - page 46
Operation QUANTRON-A
4
40
4.5.7
Spreading disc type
The mounted disc type is pre-programmed as a standard at the factory. If you
have mounted different spring discs on your machine, you must enter the correct
type in your control unit.
1.
Open the
Fertiliser settings > spreading disc
menu item.
2.
Highlight the disc type with the bar in the selection list.
3.
Press the
Enter key
.
The selected disc type is marked with a tick.
4.
Press the
ESC
key
The display shows the Fertiliser settings window with the new spread-
ing disc type.
4.5.8
PTO
The specified PTO speed is preprogrammed in the control unit to 540rpm as a
standard factory setting. If you want to specify a different PTO speed, you must
change the stored value in the control unit.
1.
Open the
Fertiliser settings > PTO
menu item.
2.
Input speed.
Refer to chapter
4.12.2: Entering values with the cursor keys, page 79
.
3.
Press the
Enter key
.
The display shows the Fertiliser settings window with the new PTO
speed.
NOTICE
For
optimal empty run measurement
, you must check the correct input in the
Fertiliser settings
menu.
The inputs in the
Spreading disc
and
PTO
menu items must absolutely
comply with the actual settings of your machine.
NOTICE
For
optimal empty run measurement
, you must check the correct input in the
Fertiliser settings
menu.
The inputs in the
Spreading disc
and
PTO
menu items must absolutely
comply with the actual settings of your machine.
NOTICE
Please observe chapter
: Mass flow control with the M EMC function, page 85
.