D-Link DS-3550 Command Line Interface Reference Manual - page 105
97
To set the ingress checking status, the sending and receiving GVRP information :
DES-3550:4#config gvrp 1-4 state enable ingress_checking enable
acceptable_frame tagged_only pvid 2
Command: config gvrp 1-4 state enable ingress_checking enable
acceptable_frame tagged_only pvid 2
Success.
DES-3550:4#
enable gvrp
Purpose
Used to enable GVRP on the switch.
Syntax
enable gvrp
Description
This command, along with disable gvrp below, is used to enable
and disable GVRP on the switch, without changing the GVRP
configuration on the switch.
Parameters None.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To enable the generic VLAN Registration Protocol (GVRP):
DES-3550:4#enable gvrp
Command: enable gvrp
Success.
DES-3550:4#
disable gvrp
Purpose
Used to disable GVRP on the switch.
Syntax
disable gvrp
Description
This command, along with disable gvrp below, is used to enable
and disable GVRP on the switch, without changing the GVRP
configuration on the switch.
Parameters None.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To disable the Generic VLAN Registration Protocol (GVRP):