D-Link DS-3550 Command Line Interface Reference Manual - page 61
53
9
N
ETWORK
M
ONITORING
C
OMMANDS
The network monitoring commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command Parameters
show packet ports
show error ports
show utilitzation
[cpu | ports {
clear counters
ports
clear log
show log
index
enable syslog
disable syslog
show syslog
create syslog host
[informational|warning|all]| facility[local0|local1|local2|local3|
local4|local5|local6|local7] |udp_port
state[enable|disable]
config syslog host
[all |
[local0|local1|local2|local3|local4|local5|local6|local7] |udp_port
disable]}
delete syslog host
all
show syslog host
Each command is listed, in detail, in the following sections.
show packet ports
Purpose
Used to display statistics about the packets sent
and received by the switch.
Syntax
show packet ports
Description
This command is used to display statistics about
packets sent and received by ports specified in
the port list.
Parameters
− specifies a port or range of ports to
be displayed.
Restrictions None.
Example usage:
To display the packets analysis for port 7 of module 2: