D-Link DS-3550 Command Line Interface Reference Manual - page 111
103
create link_aggregation
Restrictions
Only administrator-level users can issue this command.
Example usage:
To create a link aggregation group:
DES-3550:4#create link_aggregation group_id 1
Command: create link_aggregation group_id 1
Success.
DES-3550:4#
delete link_aggregation group_id
Purpose
Used to delete a previously configured link aggregation group.
Syntax
delete link_aggregation group_id
Description
This command is used to delete a previously configured link
aggregation group.
Parameters
− Specifies the group id. The switch allows up to 6 link
aggregation groups to be configured. The group number identifies
each of the groups.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To delete link aggregation group:
DES-3550:4#delete link_aggregation group_id 6
Command: delete link_aggregation group_id 6
Success.
DES-3550:4#
config link_aggregation
Purpose
Used to configure a previously created link aggregation group.
Syntax
config link_aggregation group_id
Description
This command allows you to configure a link aggregation group that
was created with the create link_aggregation command above.
The DES-3550 supports link_aggregation cross box which specifies
that link aggregation groups may be spread over multiple switches in
the switching stack.