D-Link DS-3550 Command Line Interface Reference Manual - page 41
33
restricted 1.3.6.1.6.3.10.2.1 Included
restricted 1.3.6.1.6.3.11.2.1 Included
restricted 1.3.6.1.6.3.15.1.1 Included
CommunityView 1 Included
CommunityView 1.3.6.1.6.3 Excluded
CommunityView 1.3.6.1.6.3.1 Included
Total Entries: 11
DES-3550:4#
create snmp community
Purpose
Used to create an SNMP community string to define the relationship
between the SNMP manager and an agent. The community string
acts like a password to permit access to the agent on the switch.
One or more of the following characteristics can be associated with
the community string:
An Access List of IP addresses of SNMP managers that are
permitted to use the community string to gain access to the switch’s
SNMP agent.
An MIB view that defines the subset of all MIB objects that will be
accessible to the SNMP community.
Read|write or read-only level permission for the MIB objects
accessible to the SNMP community.
Syntax
create snmp community
Description
The create snmp community command is used to create an SNMP
community string and to assign access-limiting characteristics to this
community string.
Parameters
− An alphanumeric string of up to 32
characters that is used to identify members of an SNMP community.
This string is used like a password to give remote SNMP managers
access to MIB objects in the switch’s SNMP agent.
− An alphanumeric string of up to 32 characters
that is used to identify the group of MIB objects that a remote SNMP
manager is allowed to access on the switch.
read_only
− Specifies that SNMP community members using the
community string created with this command can only read the
contents of the MIBs on the switch.
read_write
− Specifies that SNMP community members using the
community string created with this command can read from and
write to the contents of the MIBs on the switch.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To create the SNMP community string “dlink:”