D-Link DS-3550 Command Line Interface Reference Manual - Igmp S
110
19
IGMP S
NOOPING
C
OMMANDS
The switch port commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
config igmp_snooping
[
| router_timeout < sec 1-16711450> | leave_timer < sec
0-16711450> | state [enable | disable]}
config igmp_snooping
querier
[
max_response_time
25> | state [enable | disable] config router_ports enable igmp snooping forward_mcrouter_only show igmp snooping vlan disable igmp snooping show igmp snooping group vlan show router ports {vlan show igmp_snooping forwarding {vlan Each command is listed, in detail, in the following sections. config igmp_snooping Purpose Used to configure IGMP snooping on the switch. Syntax config igmp_snooping [ leave_timer < sec 0-16711450> | state [enable | disable]} Description This command allows you to configure IGMP snooping on the switch. Parameters − The name of the VLAN for which IGMP snooping is to be configured. host_timeout − Specifies the maximum amount of time a host can be a member of a multicast group without the switch receiving a host membership report. The default is 260 seconds. router_timeout − Specifies the maximum amount of time a route can be a member of a multicast group without the switch receiving a host membership report. The default is 260 seconds. leave_timer − Specifies the amount of time a Multicast address will stay in the database before it is deleted, after it has sent out a leave group message. An entry of zero (0) specifies an immediate deletion of the Multicast address. The default is 2