D-Link DS-3550 Command Line Interface Reference Manual - page 168
160
config mac_notification ports
Description
MAC address notificiation is used to monitor MAC addresses learned
and entered into the FDB.
Parameters
all – Entering this command will set all ports on the system.
enable / disable – These commands will enable or disable MAC
address table notification on the switch.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To enable port 7 for MAC address table notification:
DES-3550:4#config mac_notification ports 7 enable
Command: config mac_notification ports 7 enable
Success.
DES-3550:4#
show mac_notification
Purpose
Used to display the switch’s MAC address table notification global
settings
Syntax
show mac_notification ports
Description
This command is used to display the switch’s MAC address table
notification global settings.
Parameters None.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To view the switch’s MAC address table notification global settings:
DES-3550:4#show mac_notification
Command: show mac_notification
Global Mac Notification Settings
State : Enabled
Interval : 1
History Size : 1
Success.
DES-3550:4#